DF - Sleep and PNP (disable and enable) with IO Before and After (Certification)

This test cycles the system through various sleep states and performs IO and basic PnP (enabled and disable) on devices before and after each sleep state cycle.

For information included in the Windows Driver Kit on this test, see Sleep Tests (Device Fundamentals) (Windows Drivers).

Test details

Associated requirements

Device.BusController.UsbController.MaintainDeviceStateOnResumeS1andS3 Device.BusController.UsbController.MustResumeWithoutForcedReset Device.DevFund.DriverFramework.KMDF.Reliability Device.DevFund.DriverFramework.UMDF.Reliability Device.DevFund.Reliability.BasicReliabilityAndPerformance Device.DevFund.Reliability.S3S4SleepStates

See the device hardware requirements.

Platforms

Windows 7 (x64) Windows 7 (x86) Windows RT (ARM-based) Windows 8 (x64) Windows 8 (x86) Windows Server 2012 (x64) Windows Server 2008 R2 (x64) Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86 Windows Server 2012 R2

Expected run time

~45 minutes

Categories

Certification

Type

Automated

 

Running the test

Before you run the test, complete the test setup as described in the test requirements: Device.Fundamentals Reliability Testing Prerequisites.

Troubleshooting

For troubleshooting information, see Troubleshooting Device Fundamentals Reliability Testing by using the Windows HCK.

More information

Parameters

Parameter Description

WDTFREMOTESYSTEM

This parameter is required only if the device under test, or one of its child devices, is a wired network adapter that does not have an IPv6 gateway address. If this parameter is required on your network, you must provide an IPv6 address that the test network adapter can ping to test network.

Example: fe80::78b6:810:9c12:46cd

Wpa2PskAesSsid

This parameter is required only if the device under test or one of its child devices is a WiFi adapter. Provide the SSID of a WPA2 AES WiFi network that the test can use to test the WiFi adapter.

Default value: kitstestssid

Wpa2PskPassword

This parameter is required only if the device under test or one of its child devices is a WiFi adapter. Provide password of the WPA2 AES WiFi network that is specified by using the Wpa2PskAesSsid parameter.

Default value: password

 

 

 

Send comments about this topic to Microsoft